Instructions for Using your Effusion Lamp

Step 1 – Open

• Always place your La-Tee-Da! Effusion Lamp on a flat, protected and stable surface. We suggest a plate, glass, marble or stoneware surface.
• Do not place directly on Wood or Finished Surface.
• Put the Vented Crown and Solid Metal Cap beside your Effusion lamp to avoid misplacement.

Step 2 – Fill

• Use La-Tee-Da! Effusion Lamp Fragrances ONLY. Our fragrances are formulated for use exclusively with La-Tee-Da! Effusion Lamp stone burners.
• Use the funnel to pour the Effusion Fragrance into the Lamp. Fill the lamp ½ to 2/3 full.
• DO NOT OVERFILL – (Your La-Tee-Da! Effusion Lamp will not function properly)
• Wipe lamp, carefully, to clean any fragrance spills.

Step 3 – Insert Wick

• While holding the Effusion Lamp, insert the Wick Assembly (Burner). It should fit into the collar and be fully seated.
• Replace the solid metal cap.
• Wait 20 to 30 minutes before lighting. This will allow the Effusion fragrance to saturate the wick & burner. (The Effusion burner stone will appear darkened or wet when saturated.)

Step 4 – Light

• Take off the solid metal cap.
• Light the Effusion burner using a match or lighter.
• Let flame burn for 2-3 minutes. (Flame will be 5-6” in height, then settle to 1-2”.) When the flame reduces the burner has reached the proper temperature. Take a short meditation moment. DO NOT leave the flame unattended.
• Blow out the flame. Your La-Tee-Da! Effusion Lamp is now working.
• Once the flame has been blown out, replace only the vented crown over the burner. This will protect the burner from being touched. Just put the solid metal cap to the side until you are ready to extinguish your lamp. (Do not ever place crown on lamp while flame is burning, this will ruin your crown!)

Step 5 – Use

• Leave the Effusion burner open (on) for as long as you require fragrance to be released. It typically takes 30 to 45 minutes to fragrance an average size home. When you are finished place the solid metal cap firmly back on your lamp to extinguish the burner by depriving it of oxygen. Place vented crown back on top of lamp & metal cap until your next use.